National Homebrew Club Ireland

Brewing Discussions => Best Recipes => Topic started by: Peadargls on April 12, 2021, 12:13:12 PM

Title: Guinness clone recipe/ advice
Post by: Peadargls on April 12, 2021, 12:13:12 PM
Hello all,

I have been homebrewing for about a year now and have become addicted! I have decided to try and make a Guinness clone since i have the correct 75/25 gas ready to go. I am finding it difficult to put together the best recipe as there are many opinions. Also, not sure if the method varies much. I have seen a lot of different takes on the souring process. Any ideas or set recipes/ instructions would be greatly appreciated! All the best

PS. i came across a few different takes that seem interesting and have included them below. The first one is from this thread but not sure as to which exact ingredients i should pick up.

------------------------------------------------
70% pale, 20% flaked, 10% roasted, 10% brown - close match
------------------------------------------------

Another option from TheHomeBrewAcademy on youtube:
------------------------------------------------
https://homebrewacademy.com/guinness-recipe/
------------------------------------------------

I found this one online which looks interesting and detailed:
------------------------------------------------
9 lbs Brit pale ale
1 lb flaked barley
18 oz roast barley
12 oz carapils
1.5 oz No. Brewer hops (60 min)
1 oz East Kent Goldings hops (60 min)

First, get the "tang" the way Guinness does: Sour about 24 oz (2 bottles) of stout (pref. Guinness) by leaving it out in a bowl a week or more & then freezing it.
While brewing, thaw the sour stout & heat it to 180-190 F for 20 min.
Mash-in at 155F, hold for 1 hour, boil 1 hour & 15 minutes.
At end boil, add the sour stout.
At 70F, pitch 2 packs of Wyeast #1084.
A month or so of cold lagering (<40F) after bottling or kegging will help.
A certified beer judge could not tell this from bottled Guinness.
Link - http://ericsbeerpage.com/Beer/Recipe/guin.htmlIngredients:
Title: Re: Guinness clone recipe/ advice
Post by: phildo79 on April 12, 2021, 01:13:49 PM
Have you got the correct tap and reg for the job? There is another thread on here about the equipment needed. I thought it was just the gas but apparently not.
Title: Re: Guinness clone recipe/ advice
Post by: Peadargls on April 12, 2021, 01:28:51 PM
Hiya Phil,

Yeah i have the correct tap and reg etc. ready to go.

The recipe is the killer! I understand that there is no correct answer but i would love to get a semi-correct one  ;D  ;D

Thanks
Title: Re: Guinness clone recipe/ advice
Post by: phildo79 on April 13, 2021, 01:38:39 PM
I have a Guinness recipe from Omnipollo. I could upload a photo for you but you will need to translate it from Swedish. But looking at it now, it doesn't mention adding sour beer. It does mention a small amount of acid malt and cereal flakes though.
Title: Re: Guinness clone recipe/ advice
Post by: DEMPSEY on April 14, 2021, 10:17:47 PM
The 70% pale, 20% flaked,and 10% roasted is an excellent recipe for doing this. bittering is in the 60 minute boil and aim for 23 IBU's and go for about 4.2%abv. I did it once and swapped out2% of the roast and added 2% acidulated malt to try add a bit of souring that Guinness has. You could move that to 3% but note that this lowers your PH so take that into consideration.
Title: Re: Guinness clone recipe/ advice
Post by: Peadargls on April 14, 2021, 11:44:43 PM
That's great. Thanks all!