More Raspberry Pi stuff for your projects

[pob]

Just wondering, will any of this fit onto the Pi Zero W*?



So, if I put a drone into my mashtun, will it provide optimum mixing?


_{*morning nerdfest}

[DEMPSEY]

Hah it will certainly add oxygen but that's what you don't want to add

[dcalnan]

Mine arrived today, still not sure what to do with it yet.

[brian_c]

Anyone recommend a temperature probe that'd work with the pi? Thinking of something that can record temp through fermentation, maybe even check in on it from work on my phone.

Sent from my phone, please excuse the typos.

[pob]

Only one to consider is DS18B20, digital that most use.

Might need a 6-8mm ID thermowell

[darren996]

Anyone recommend a temperature probe that'd work with the pi? Thinking of something that can record temp through fermentation, maybe even check in on it from work on my phone.

Sent from my phone, please excuse the typos.

Have a look at this thread

http://www.homebrewtalk.com/showthread.php?t=586476

You could build a brewpi with a pi zero w setup for about 40 euro.

Brewpi will fit on a 4 gig sd card. Get a Transend class

https://www.ebay.ie/itm/182210923621


5 pcs DS18b20 Waterproof Temperature Sensors Temperature Transducer https://www.amazon.co.uk/dp/B00CHEZ250/ref=cm_sw_r_cp_api_RLOWyb67K76NN

[brian_c]

Have a look at this thread

http://www.homebrewtalk.com/showthread.php?t=586476

You could build a brewpi with a pi zero w setup for about 40 euro.

Brewpi will fit on a 4 gig sd card. Get a Transend class

https://www.ebay.ie/itm/182210923621


5 pcs DS18b20 Waterproof Temperature Sensors Temperature Transducer https://www.amazon.co.uk/dp/B00CHEZ250/ref=cm_sw_r_cp_api_RLOWyb67K76NN

That's my weekend gone anyway

[rukkus]

What cables do you use when going from gpio to a SSR?

[darren996]

What cables do you use when going from gpio to a SSR?

I use female to male DuPont cables.  If you want to get fancy you can use a bread board as well.

https://www.ebay.ie/itm/272153083323

You will also need a 4.7k resistor

If you don't use DuPont you will have to solder to the gpio header