Have a kegerator setup with two kegs, two taps with compensators and dual gage regulator. Both lines are about two metres.
Have a problem whereby they're off gassing. They were pouring ok and I decided to clean the lines as they were due but on reconnecting them I'm just getting foam.
Loads of foam and flat beer!
Have had this before when I'd like to serve a highly carbed beer. Get to where I'm happy and then it starts getting foamy, drop the pressure and it's just worse. Is it just the line length?
Hope this makes sense.
Welcome to the forum.
Did you got sorted with this?
Rather than throw down the gauntlet with a problem straight away why not do an intro?
Who/Where/Kit/Allgrain/level of expertise?