Text only | Text with Images

National Homebrew Club Ireland

Brewing Discussions => Equipment & Chemicals => Topic started by: DEMPSEY on May 31, 2013, 05:07:15 PM

Title: gas reg fitting?
Post by: DEMPSEY on May 31, 2013, 05:07:15 PM
I have these 2 gas reg's that came out of a pub cellar but the connection's are such that I have never seen what they connect to. The reg's are sealed and pre set at a given pressure. Any idea's,
Title: Re: gas reg fitting?
Post by: DEMPSEY on June 26, 2013, 02:23:25 PM
Bumping this,has anyone got a link to where I could have this crappy gas connector replaced with a connector for a mixed gas bottle. The reg's appear to be fine.
Title: Re: gas reg fitting?
Post by: alealex on June 27, 2013, 03:40:21 AM
What way is the high pressure hose connected to regulator? I might have a spare one with fine thread going into regulator and standard gas cylinder fitting.
Title: Re: gas reg fitting?
Post by: DEMPSEY on July 01, 2013, 11:48:02 AM
Alealex,this is the gas connection to the reg,I want to change from this odd looking fitting to a mixed gas fitting for a mixed gas pub bottle.
Title: Re: gas reg fitting?
Post by: alealex on July 01, 2013, 03:05:09 PM
Diameter of thread going into reg: 9,9mm - 8,7mm (15mm spanner)
diameter of gas cylinder thread: 22,5mm - 20,5mm (28mm spanner)
Hope it's the one you're looking for.
Title: Re: gas reg fitting?
Post by: DEMPSEY on July 01, 2013, 03:12:54 PM
Not too clear on the picture but is the connection to the reg a male fitting.
Title: Re: gas reg fitting?
Post by: alealex on July 01, 2013, 03:31:02 PM
Yes, male fitting.
Text only | Text with Images