Text only | Text with Images

National Homebrew Club Ireland

Brewing Discussions => Equipment & Chemicals => Topic started by: baconsarnie on December 18, 2013, 09:33:52 AM

Title: Barbed disconnects for kegerator taps
Post by: baconsarnie on December 18, 2013, 09:33:52 AM
Have four taps, 2 from the group buy which have barbed disconnects, and two without, which means I have to use JG fittings for those to connect to the kegs

Kinda fed up with JG fittings- prefer the ease of barbed disconnects- so my question is- can you buy them somewhere separately?
Title: Re: Barbed disconnects for kegerator taps
Post by: baconsarnie on February 27, 2014, 11:10:29 AM
Looking to avoid using JG where possible. Some of them are less than easy to disconnect at cleaning time! I'd prefer the ease of barbed fittings & jubilee clips

Is there somewhere that sells stainless steel stem elbows separately?
Title: Re: Barbed disconnects for kegerator taps
Post by: johnrm on February 27, 2014, 11:27:22 AM
If they are less than easy to disconnect either you need to be cleaning your lines with greater frequency or you need younger hands!
Title: Re: Barbed disconnects for kegerator taps
Post by: baconsarnie on February 27, 2014, 02:30:13 PM
The latter, and that may well be the problem!  ::)
Title: Re: Barbed disconnects for kegerator taps
Post by: johnrm on February 27, 2014, 02:45:22 PM
Is there a GoodGrips/OXO JG tool yet?  >:D
Text only | Text with Images