Hi there
I have a beer keg system that takes 8gr Co2 cartridges. I want to instead connect it to my Co2 canister using a gas cornie disconnect. The existing King keg is 3/4" male threaded unit that takes a plastic 3/4" female receptacle that screws on to male thread. What I would like to is find a 3/4" female adaptor that converts to a male threaded end. I am not sure of the size of male but it would to allow a keg post to be screwed on to it.
Can anybody confirm the size of the diameter required to take a cornie gas past? Also where n might n one go about getting such a thing?
Thanks
Shanna
Edit: corrected description of King keg to Beer King keg.
A gender changer.
Would a 3/4" nipple and PTFE do it?
I've done this in the past. There is as connector you can buy. I'll try dig it out and post a PIC.
Quote from: johnrm on January 12, 2014, 08:16:24 PM
A gender changer.
Would a 3/4" nipple and PTFE do it?
Its a gender changer and a size step down
3/4" female to ?/?" male where ?/? is the size that a cornie keg gas post would fit on.
Shanna
Quote from: Rossa on January 12, 2014, 08:54:11 PM
I've done this in the past. There is as connector you can buy. I'll try dig it out and post a PIC.
Hey Rossa, thanks for that. Any idea where you got it?
Shanna
HbC I'd thnk
Just to confirm that its for a Beer King CO2-dispenser for 5 l barrels - see
https://www.thehomebrewcompany.ie/beer-king-co2dispenser-for-5-l-barrels-p-294.html
Shanna
Here you go Shanna i believe this is what you are looking for ? ;D
http://brewingathome.co.uk/product/midget-widget-world-universal-barrel-hose/
Quote from: Greg2013 on January 13, 2014, 01:11:26 PM
Here you go Shanna i believe this is what you are looking for ? ;D
http://brewingathome.co.uk/product/midget-widget-world-universal-barrel-hose/
That's the one.