OK! I bought a new Brewferm Mill and in putting it together I was slightly surprised that (a) the crank handle won't go on to the shaft without the aid of a lump hammer and (b) only one of the rollers turns when the shaft is turned. ??? The means of adjusting the roller gap seems a bit strange too.
Anyone with experience using this particular mill able to offer any advice?
The instructions that accompanied the mill are woefully short on details or information.
p 8)
One roller turning is standard. The grain will turn the other as they go through.
Nice one :D thanks for that. At least I know it's not a dud ::)
P 8)
got the handle on and off easy enough, just took a bit of wiggling. agree that the instructions are really bad, espically when it says "assemble as shown" with just a small full size picture, before i started i though i was missing 2 nuts.
changing the gap is a bit fiddly but once it gets set properly your not going to be changing it very often.
Quote from: beerfly on February 13, 2014, 10:03:30 AM
got the handle on and off easy enough, just took a bit of wiggling. agree that the instructions are really bad, espically when it says "assemble as shown" with just a small full size picture, before i started i though i was missing 2 nuts.
changing the gap is a bit fiddly but once it gets set properly your not going to be changing it very often.
That's funny because mine was msiing a couple nuts as well.
turns out i had everything, just looked like some were missing