The dial on the left in the picture below is the one that shows the level of CO2 remaining in my tank and it has been busted for a while now.Does anyone have a handy link to where i can get the correct replacement part for this ? The regulator was bought from Alex when i first started kegging if that helps. ;D
A m8 in Australia just came up with this link for me but before ordering i wanted to check with ye here that it is the right thread etc. ? ;D
http://www.ebay.com/itm/Co2-Pressure-Gauge-1-4-Inch-2000-PSI-Right-Side-Mount-G2042-2000C-/371063831918
Greg, I doubt it they state 1/4" NPT Our gauges are highly likely to be BSP.
They are different tpi's and at these pressures you don't piss about.
Go to a welding suppliers and they may have a spare HP gauge from a scrapped Reg!
Quote from: Will_D on June 11, 2015, 10:32:11 PM
Greg, I doubt it they state 1/4" NPT Our gauges are highly likely to be BSP.
They are different tpi's and at these pressures you don't piss about.
Go to a welding suppliers and they may have a spare HP gauge from a scrapped Reg!
I dont thin there are any about here but i will have a look WillD thanks. ;D
The same Aussie m8 got me this link but as he said i need to know exactly which one i need before ordering online as i don't have a physical shop to go into,so any help on narrowing down the correct gauge would be appreciated from the more technical minded. ;D
http://www.candirect.de/Inhaltsmanometer-fuer-Druckminderer
Greg, if you're after the one from CanDirect - I'll be happy to take one myself.
Busted it in January and have no idea where am I with the CO2 level now.
Quote from: Bart on June 15, 2015, 01:09:15 PM
Greg, if you're after the one from CanDirect - I'll be happy to take one myself.
Busted it in January and have no idea where am I with the CO2 level now.
PM me there and we will work it out. ;D