Brewferm Grain Mill

[Parrot]

OK! I bought a new Brewferm Mill and in putting it together I was slightly surprised that (a) the crank handle won't go on to the shaft without the aid of a lump hammer and (b) only one of the rollers turns when the shaft is turned.  The means of adjusting the roller gap seems a bit strange too.

Anyone with experience using this particular mill able to offer any advice?

The instructions that accompanied the mill are woefully short on details or information.

p

[imark]

One roller turning is standard. The grain will turn the other as they go through.

[Parrot]

Nice one thanks for that. At least I know it's not a dud :

P

[beerfly]

got the handle on and off easy enough, just took a bit of wiggling.  agree that the instructions are really bad, espically when it says "assemble as shown" with just a small full size picture, before i started i though i was missing 2 nuts.
changing the gap is a bit fiddly but once it gets set properly your not going to be changing it very often.

[AJ_Rowley]

got the handle on and off easy enough, just took a bit of wiggling.  agree that the instructions are really bad, espically when it says "assemble as shown" with just a small full size picture, before i started i though i was missing 2 nuts.
changing the gap is a bit fiddly but once it gets set properly your not going to be changing it very often.

That's funny because mine was msiing a couple nuts as well.

[beerfly]

turns out i had everything, just looked like some were missing