Busted pressure gauge on regulator

[dcalnan]

So last night I noticed that the pressure gauge on my co2 regulator got smashed somehow. I checked it for leaks and there's nothing leaking, thankfully I had the tank closed at the time. Does anyone know where I could pick up a replacement one in Ireland , it's the dual output regarding from Alex, and the 0-250 bar gauge. I'll post a pic later as I'm on my phone and tapatalk isn't letting me log in.

[mcgrath]

Broke mine too if it makes you feel any better. Doesn't take much, they are pretty exposed. I didn't replace it because I'd probably break it again.

[Leann ull]

Both still work fine, don't rely on pressure gauge to tell you fill status of your tank.

[imark]

Same as mcgrath. Mine is busted too but not leaking. It's not really required in my opinion. The low pressure gauge on outputs are more important.

[dcalnan]

Ah I mightnt replace it then, I only took out the keg to install a wire chain to stop it falling over, and of course it gets damaged then.

[Leann ull]

Doh, I popped back in the plastic cover a few times but these 2 are for my portable set up so not bothered.

[Ed]

you need one of these bad boys 

On a related note - i bought my reg used from ebay, one of the gauges was damaged when they shipped it, but I just bent the housing back into shape and it worked fine - same reg as the grey one in CH's post, damage wasn't much worse that that one either, but it's grand.

[Leann ull]

That's a bike with stabilisers

[Ed]

That's a bike with stabilisers

well, if you need them...