What do I need to connect this to this

[admin]

1/4" BSPT



This is apparently a 7/16" something or other:

[Ciderhead]

Would rear entry not be better
http://item.mobileweb.ebay.ie/viewitem?itemId=121046550468&index=1&nav=SEARCH&nid=14112882716

These guys also do fittings

[Ciderhead]

http://www.homebrewtalk.com/f39/monitor-corny-keg-pressure-206650/

[Ciderhead]

Ka Ching

http://www.hopandgrape.co.uk/public/detailv1.asp?itemcode=NEW20226619

[Ciderhead]

11 to NI, jeez Louise

[johnrm]

Are you working on a spunding valve Shane?

[Ciderhead]

I think JG connectors with a small bit of pipe is easiest option.
I have ordered a gauge and will show you result when it arrives

[Ciderhead]

I think JG connectors with a small bit of pipe is easiest option.
I have ordered a gauge and will show you result when it arrives

Just made one of these for testing keg pressure rather than fermenting in a keg







From one of these
http://www.ebay.ie/itm/ws/eBayISAPI.dll?ViewItem&item=121046550468&ssPageName=ADME:L:OU:IE:1123#ht_983wt_1154
one of these
http://www.ebay.ie/itm/ws/eBayISAPI.dll?ViewItem&item=120932160747&ssPageName=ADME:L:OU:IE:1123#ht_1019wt_897
and one of these
http://www.ebay.co.uk/itm/1-4Bsp-x-1-4-Hose-Tail-To-Suit-6mm-ID-Hose-Pack-Of-2-/290555767612?ssPageName=ADME:L:OC:IE:3160

with a bit of grey gas pipe forced over the end 

other end is just my JG and a post

Only problem is after I remove it it hold the pressure when jumping across to another keg so I end out depressing barb in the post to release, some kind of release valve would work easier.
I made it as not all my kegs are continuously pressurised and I think one has a slow leak

[Ciderhead]

sorry I should have said it doesnt drop to zero and I have to release the pressure if I am looking for a reading on the next keg below the last reading, hence my requirement to release pressure

[Ciderhead]

you are absolutely right it equalises and reverts to the lower pressure, very useful for measuring force carbed bottles for the competiton